Hardwired EV Charger Installation in Sandy Springs
Permanent, higher-amperage chargers for garages, carports and driveway walls from Glenridge Drive to Dunwoody Club Drive.
Georgia-licensed · EVITP-certified · Permit and inspection included
Built-In Charging for Higher Power and Outdoor Durability
A hardwired charger connects directly to its circuit with no plug in between, which lets it run on a 60-amp circuit and deliver up to 48 amps to the car. For Sandy Springs drivers with long commutes, two EVs or a charger mounted outside by the driveway, that combination of speed and weather resistance is hard to beat. Sandy Springs EV Charger Installation plans each hardwired install around your panel capacity, the mounting surface and the path from the breaker to the charger. We use weather-rated conduit and fittings for exterior mounts, set the charger's output to match the breaker and pull the city permit. You end up with a clean, permanent installation that looks like it was designed with the house.
What Our Hardwired Charger Service Includes
Hardwiring takes a little more planning than an outlet, and every step is part of the job.
60-amp circuit when capacity allows
We confirm through a load calculation that your panel can support a 60-amp circuit for full 48-amp charging.
Direct termination at the charger
Conductors land directly on the charger's terminals with no plug or receptacle, removing a common point of heat and wear.
Exterior-rated conduit and fittings
Outdoor runs use weather-resistant conduit, sealed fittings and proper supports for Georgia heat and heavy rain.
Disconnect where required
If code or the charger's location calls for a local disconnect, we install one within sight of the unit.
Masonry and siding mounting
We anchor chargers to brick, stone, siding or stud walls using the right hardware for each surface.
Output configuration
The charger's maximum current is set to match the breaker so it always charges within safe limits.
Smart features and scheduling
Connected chargers are paired with Wi-Fi so you can schedule charging and track usage.
Dual-EV planning
For two-car households we can plan load sharing or a second circuit so both vehicles charge overnight.
Permit and inspections
We file the City of Sandy Springs permit and handle the rough and final inspections.
Live test session
We plug in your vehicle and confirm full-rate charging before we leave.
The Path to a Hardwired Charger
Site review and price
We look at your panel, the mounting wall and the route between them. The load calculation confirms the circuit size. You get a written flat price that includes the permit. There is no cost for the estimate.
Charger choice and permit
If you have not bought a charger, we recommend hardwire-capable units that fit your car and circuit. Then we file the permit and schedule your install day. Exterior jobs are planned around the weather forecast.
Install and inspection
We run conduit, terminate the charger and configure its output. Most hardwired installs take part of a day, longer for exterior runs. We schedule and attend the inspection and send you the closed permit.
Why Choose Sandy Springs EV Charger Installation for a Hardwired Charger
Faster charging, safely delivered
We only set up a 60-amp circuit after the load math supports it, so faster charging never comes at the expense of your panel.
Outdoor installs built for Georgia weather
Summer storms and humidity are hard on cheap fittings. We use materials meant to stay sealed for years.
A finish that looks intentional
Straight conduit runs, tidy mounting and painted-to-match options where possible keep the install from looking like an afterthought.
Ready for Faster, Permanent Charging?
A hardwired charger is the closest thing to a set-and-forget setup. Tell us where you park and send a photo of your panel, and we will map out the circuit and price.
(404) 476-5021Free estimates · Written flat-rate pricing · Permit filed for you